General Information :


The AMF panel consists of controls and power circuitry to take in Power supplies from two independent sources (Mains supply and Generator supply)

The AMF panel works in different modes of operation :

1. AMF MODE : In the AMF mode (selected by Selector Switch 1) the entire operation of Generator starting, stoppin and change over of load is automatic. First select the AMF mode through the Selctor Switch 1. If the main supply is available the Mains "ON" indicating lamp will light and the Load is automatically connected to the mainds. Whenever the mains supply fails the selected Generator is automatically started and the load is transferred to the generator when it starts. In case the Generator does not start after ....... unsuccessful attempts or if any of the failure (Low Oil pressure, High engine temperatur, V-Belt failure) occurs then the fails to start indication will come.

2. BYPASS MODE : In this mode the total operation of starting, stopping and changeover of load is done manually. When Bypass mode is selected through Selector Swith 1 the load is connected either to the mains or the Generator through the Selector Switch 2 (EB/DG). In the EB position the load is connected to the mains if the mains supply is normal. In the DG position the Generator is connected to the load. The Generator can be started and stopped through the Start and Stop Pushbuttons.

Note: Specifications and the image may vary As per customer requirement.
Copyright 2007-2010 Altex Electric Company. All rights reserved.